Project 1: Galaxy Resin Art Tile
Materials Needed:
- Ceramic tile or wood panel (as base)
- GlassCast 10 resin
- Pinata alcohol inks, acrylic paint, or resin pigments (black, blue, purple, white)
- Mixing tools and a heat gun or gas torch
Steps:
- Seal the tile or wood with a primer or white base coat (optional).
- Mix the resin and divide it into separate cups for each colour.
- Pour black resin as your base.
- Add blue, purple, and white in swirling patterns.
- Use a heat gun or hairdryer to move the resin and blend colours.
- Add white dots or streaks with a stick for stars and galaxies.
- Cure and optionally gloss coat again for a super glassy finish.
Project 2: Embedded Flowers Coasters
Materials Needed:
- GlassCast 10 resin & hardener
- Silicone coaster molds
- Dried flowers (pressed or whole)
- Mixing cups and stirrers
- Gloves and protective gear
- Heat gun or gas torch (for bubbles)
Steps:
- Prep your space – Cover your workspace, wear gloves, and make sure the area is dust-free.
- Arrange your flowers in the molds before pouring. Decide on layout.
- Mix the resin according to GlassCast 10's instructions.
- Pour a thin layer into the mold and let it settle for a few minutes.
- Place the flowers gently on top. Use a stick or tweezers to arrange them.
- Pour the remaining resin to fully cover the flowers.
- Pop bubbles with a heat gun or torch.
- Cure for 24–48 hours, then pop them out of the mold. Sand edges if needed.
Project 3: Resin Crystal Pendants
Materials Needed:
- Small silicone crystal or gem molds
- GlassCast 10 resin
- Mica powders or resin dyes
- Jump rings & jewellery findings
- Mixing supplies
- Heat gun or gas torch to pop bubbles
Steps:
- Prepare the mold and gather all your colouring materials.
- Mix the resin, then divide it into small cups.
- Add mica powder or dye to each portion for colourful crystals.
- Pour into the molds, layering or swirling colours for cool effects.
- Use a toothpick to pull colour through for a marbled look.
- Pop bubbles and let cure.
- Once hardened, drill tiny holes (if needed) and attach jump rings for pendants